shithub: riscv

ref: 17f7f6be4e1a316c0f5f26ff70e047aece4de2bc
dir: /sys/src/cmd/cwfs/data.c/

View raw version
#include	"all.h"

char	*errstr9p[MAXERR] =
{
	[Ebadspc]	"attach -- bad specifier",
	[Efid]		"unknown fid",
	[Echar]		"bad character in directory name",
	[Eopen]		"read/write -- on non open fid",
	[Ecount]	"read/write -- count too big",
	[Ealloc]	"phase error -- directory entry not allocated",
	[Eqid]		"phase error -- qid does not match",
	[Eaccess]	"access permission denied",
	[Eentry]	"directory entry not found",
	[Emode]		"open/create -- unknown mode",
	[Edir1]		"walk -- in a non-directory",
	[Edir2]		"create -- in a non-directory",
	[Ephase]	"phase error -- cannot happen",
	[Eexist]	"create/wstat -- file exists",
	[Edot]		"create/wstat -- . and .. illegal names",
	[Eempty]	"remove -- directory not empty",
	[Ebadu]		"attach -- unknown user or failed authentication",
	[Enoattach]	"attach -- system maintenance",
	[Ewstatb]	"wstat -- unknown bits in qid.type/mode",
	[Ewstatd]	"wstat -- attempt to change directory",
	[Ewstatg]	"wstat -- not in group",
	[Ewstatl]	"wstat -- attempt to make length negative",
	[Ewstatm]	"wstat -- attempt to change muid",
	[Ewstato]	"wstat -- not owner or group leader",
	[Ewstatp]	"wstat -- attempt to change qid.path",
	[Ewstatq]	"wstat -- qid.type/dir.mode mismatch",
	[Ewstatu]	"wstat -- not owner",
	[Ewstatv]	"wstat -- attempt to change qid.vers",
	[Ename]		"create/wstat -- bad character in file name",
	[Ewalk]		"walk -- too many (system wide)",
	[Eronly]	"file system read only",
	[Efull]		"file system full",
	[Eoffset]	"read/write -- offset negative",
	[Elocked]	"open/create -- file is locked",
	[Ebroken]	"read/write -- lock is broken",
	[Eauth]		"attach -- authentication failed",
	[Eauth2]	"read/write -- authentication unimplemented",
	[Etoolong]	"name too long",
	[Efidinuse]	"fid in use",
	[Econvert]	"protocol botch",
	[Eversion]	"version conversion",
	[Eauthnone]	"auth -- user 'none' requires no authentication",
	[Eauthdisabled]	"auth -- authentication disabled",	/* development */
	[Eauthfile]	"auth -- out of auth files",
	[Eedge]		"at the bleeding edge",		/* development */
};

char*	wormscode[0x80] =
{
	[0x00]	"no sense",
	[0x01]	"invalid command",
	[0x02]	"recovered error",
	[0x03]	"illegal request",
	[0x06]	"unit attention",
	[0x07]	"parity error",
	[0x08]	"message reject error",
	[0x0a]	"copy aborted",
	[0x0b]	"initiator detected error",
	[0x0c]	"select re-select failed",
	[0x0e]	"miscompare",

	[0x10]	"ecc trouble occurred",
	[0x11]	"time out error",
	[0x12]	"controller error",
	[0x13]	"sony i/f II hardware/firmware error",
	[0x14]	"scsi hardware/firmware error",
	[0x15]	"rom version unmatched error",
	[0x16]	"logical block address out of range",

	[0x20]	"command not terminated",
	[0x21]	"drive interface parity error",
	[0x22]	"loading trouble",
	[0x23]	"focus trouble",
	[0x24]	"tracking trouble",
	[0x25]	"spindle trouble",
	[0x26]	"slide trouble",
	[0x27]	"skew trouble",
	[0x28]	"head lead out",
	[0x29]	"write modulation trouble",
	[0x2a]	"under laser power",
	[0x2b]	"over laser power",
	[0x2f]	"drive error",

	[0x30]	"drive power off",
	[0x31]	"no disk in drive",
	[0x32]	"drive not ready",
	[0x38]	"disk already exists in drive",
	[0x39]	"no disk in shelf",
	[0x3a]	"disk already exists in shelf",

	[0x40]	"write warning",
	[0x41]	"write error",
	[0x42]	"disk error",
	[0x43]	"cannot read disk ID",
	[0x44]	"write protect error 1",
	[0x45]	"write protect error 2",
	[0x46]	"disk warning",
	[0x47]	"alternation trouble",

	[0x50]	"specified address not found",
	[0x51]	"address block not found",
	[0x52]	"all address could not be read",
	[0x53]	"data could not be read",
	[0x54]	"uncorrectable read error",
	[0x55]	"tracking error",
	[0x56]	"write servo error",
	[0x57]	"write monitor error",
	[0x58]	"write verify error",

	[0x60]	"no data in specified address",
	[0x61]	"blank check failed",
	[0x62]	"controller diagnostics failed",
	[0x63]	"drive diagnostice failed",
	[0x64]	"diagnostice aborted",
	[0x67]	"juke diagnostice failed",
	[0x68]	"z-axis servo failed",
	[0x69]	"roter servo error",
	[0x6a]	"hook servo error",
	[0x6b]	"I/O self error",
	[0x6c]	"drive 0 error",
	[0x6d]	"drive 1 error",
	[0x6e]	"shelf error",
	[0x6f]	"carrier error",

	[0x70]	"rob made me do it",
	[0x71]	"out of range",
};

char*	tagnames[] =
{
	[Tbuck]		"Tbuck",
	[Tdir]		"Tdir",
	[Tfile]		"Tfile",
	[Tfree]		"Tfree",
	[Tind1]		"Tind1",
	[Tind2]		"Tind2",
#ifndef COMPAT32
	[Tind3]		"Tind3",
	[Tind4]		"Tind4",
	/* add more Tind tags here ... */
#endif
	[Tnone]		"Tnone",
	[Tsuper]	"Tsuper",
	[Tvirgo]	"Tvirgo",
	[Tcache]	"Tcache",
};