ref: a00b6bdbfa72a1688a866edf5f825720c9874ada
dir: /sys/src/9/kw/usbehcikw.c/
/*
* Kirkwood-specific code for
* USB Enhanced Host Controller Interface (EHCI) driver
* High speed USB 2.0.
*/
#include "u.h"
#include "../port/lib.h"
#include "mem.h"
#include "dat.h"
#include "fns.h"
#include "io.h"
#include "../port/error.h"
#include "../port/usb.h"
#include "usbehci.h"
#define WINTARG(ctl) (((ctl) >> 4) & 017)
#define WINATTR(ctl) (((ctl) >> 8) & 0377)
#define WIN64KSIZE(ctl) (((ctl) >> 16) + 1)
#define SIZETO64KSIZE(size) ((size) / (64*1024) - 1)
enum {
Debug = 0,
};
typedef struct Kwusb Kwusb;
typedef struct Kwusbtt Kwusbtt;
typedef struct Usbwin Usbwin;
/* kirkwood usb transaction translator registers? (undocumented) */
struct Kwusbtt { /* at soc.ehci */
ulong id;
ulong hwgeneral;
ulong hwhost;
ulong hwdevice;
ulong hwtxbuf;
ulong hwrxbuf;
ulong hwtttxbuf;
ulong hwttrxbuf;
};
/* kirkwood usb bridge & phy registers */
struct Kwusb { /* at offset 0x300 from soc.ehci */
ulong bcs; /* bridge ctl & sts */
uchar _pad0[0x310-0x304];
ulong bic; /* bridge intr. cause */
ulong bim; /* bridge intr. mask */
ulong _pad1;
ulong bea; /* bridge error addr. */
struct Usbwin {
ulong ctl; /* see Winenable in io.h */
ulong base;
ulong _pad2[2];
} win[4];
ulong phycfg; /* phy config. */
uchar _pad3[0x400-0x364];
ulong pwrctl; /* power control */
uchar _pad4[0x410-0x404];
ulong phypll; /* phy pll control */
uchar _pad5[0x420-0x414];
ulong phytxctl; /* phy transmit control */
uchar _pad6[0x430-0x424];
ulong phyrxctl; /* phy receive control */
uchar _pad7[0x440-0x434];
ulong phyivref; /* phy ivref control */
};
static Ctlr* ctlrs[Nhcis];
static void
addrmapdump(void)
{
int i;
ulong ctl, targ, attr, size64k;
Kwusb *map;
Usbwin *win;
if (!Debug)
return;
map = (Kwusb *)(soc.ehci + 0x300);
for (i = 0; i < nelem(map->win); i++) {
win = &map->win[i];
ctl = win->ctl;
if (ctl & Winenable) {
targ = WINTARG(ctl);
attr = WINATTR(ctl);
size64k = WIN64KSIZE(ctl);
print("usbehci: address map window %d: "
"targ %ld attr %#lux size %,ld addr %#lux\n",
i, targ, attr, size64k * 64*1024, win->base);
}
}
}
/* assumes ctlr is ilocked */
static void
ctlrreset(Ctlr *ctlr)
{
int i;
Eopio *opio;
opio = ctlr->opio;
opio->cmd |= Chcreset;
coherence();
/* wait for it to come out of reset */
for(i = 0; i < 100 && opio->cmd & Chcreset; i++)
delay(1);
if(i >= 100)
print("ehci %#p controller reset timed out\n", ctlr->capio);
/*
* Marvell errata FE-USB-340 workaround: 1 << 4 magic:
* disable streaming. Magic 3 (usb host mode) from the linux driver
* makes it work. Ick.
*/
opio->usbmode |= 1 << 4 | 3;
coherence();
}
/*
* configure window `win' as 256MB dram with attribute `attr' and
* base address
*/
static void
setaddrwin(Kwusb *kw, int win, int attr, ulong base)
{
kw->win[win].ctl = Winenable | Targdram << 4 | attr << 8 |
SIZETO64KSIZE(256*MB) << 16;
kw->win[win].base = base;
}
static void
ehcireset(Ctlr *ctlr)
{
int i, amp, txvdd;
ulong v;
Eopio *opio;
Kwusb *kw;
ilock(ctlr);
dprint("ehci %#p reset\n", ctlr->capio);
opio = ctlr->opio;
kw = (Kwusb *)(soc.ehci + 0x300);
kw->bic = 0;
kw->bim = (1<<4) - 1; /* enable all defined intrs */
ctlrreset(ctlr);
/*
* clear high 32 bits of address signals if it's 64 bits capable.
* This is probably not needed but it does not hurt and others do it.
*/
if((ctlr->capio->capparms & C64) != 0){
dprint("ehci: 64 bits\n");
opio->seg = 0;
}
/* requesting more interrupts per µframe may miss interrupts */
opio->cmd |= Citc8; /* 1 intr. per ms */
switch(opio->cmd & Cflsmask){
case Cfls1024:
ctlr->nframes = 1024;
break;
case Cfls512:
ctlr->nframes = 512;
break;
case Cfls256:
ctlr->nframes = 256;
break;
default:
panic("ehci: unknown fls %ld", opio->cmd & Cflsmask);
}
dprint("ehci: %d frames\n", ctlr->nframes);
/*
* set up the USB address map (bridge address decoding)
*/
for (i = 0; i < nelem(kw->win); i++)
kw->win[i].ctl = kw->win[i].base = 0;
coherence();
setaddrwin(kw, 0, Attrcs0, 0);
setaddrwin(kw, 1, Attrcs1, 256*MB);
coherence();
if (Debug)
if (kw->bcs & (1 << 4))
print("usbehci: not swapping bytes\n");
else
print("usbehci: swapping bytes\n");
addrmapdump(); /* verify sanity */
kw->pwrctl |= 1 << 0 | 1 << 1; /* Pu | PuPll */
coherence();
/*
* Marvell guideline GL-USB-160.
*/
kw->phypll |= 1 << 21; /* VCOCAL_START: PLL calibration */
coherence();
microdelay(100);
kw->phypll &= ~(1 << 21);
v = kw->phytxctl & ~(017 << 27 | 7); /* REG_EXT_FS_RCALL & AMP_2_0 */
switch (m->socrev) {
default:
print("usbehci: bad 6281 soc rev %d\n", m->socrev);
/* fall through */
case Socreva0:
amp = 4;
txvdd = 1;
break;
case Socreva1:
amp = 3;
txvdd = 3;
break;
}
/* REG_EXT_FS_RCALL_EN | REG_RCAL_START | AMP_2_0 */
kw->phytxctl = v | 1 << 26 | 1 << 12 | amp;
coherence();
microdelay(100);
kw->phytxctl &= ~(1 << 12);
v = kw->phyrxctl & ~(3 << 2 | 017 << 4); /* LPF_COEF_1_0 & SQ_THRESH_3_0 */
kw->phyrxctl = v | 1 << 2 | 8 << 4;
v = kw->phyivref & ~(3 << 8); /* TXVDD12 */
kw->phyivref = v | txvdd << 8;
coherence();
ehcirun(ctlr, 0);
ctlrreset(ctlr);
iunlock(ctlr);
}
static void
setdebug(Hci*, int d)
{
ehcidebug = d;
}
static void
shutdown(Hci *hp)
{
Ctlr *ctlr;
Eopio *opio;
ctlr = hp->aux;
ilock(ctlr);
ctlrreset(ctlr);
delay(100);
ehcirun(ctlr, 0);
opio = ctlr->opio;
opio->frbase = 0;
coherence();
iunlock(ctlr);
}
static void
findehcis(void) /* actually just use fixed addresses on sheeva */
{
int i;
Ctlr *ctlr;
static int already = 0;
if(already)
return;
already = 1;
ctlr = smalloc(sizeof(Ctlr));
/* the sheeva's usb 2.0 otg uses a superset of the ehci registers */
ctlr->capio = (Ecapio *)(soc.ehci + 0x100);
ctlr->opio = (Eopio *) (soc.ehci + 0x140);
dprint("usbehci: port %#p\n", ctlr->capio);
for(i = 0; i < Nhcis; i++)
if(ctlrs[i] == nil){
ctlrs[i] = ctlr;
break;
}
if(i == Nhcis)
print("ehci: bug: more than %d controllers\n", Nhcis);
}
static int
reset(Hci *hp)
{
static Lock resetlck;
int i;
Ctlr *ctlr;
Ecapio *capio;
ilock(&resetlck);
findehcis();
/*
* Any adapter matches if no hp->port is supplied,
* otherwise the ports must match.
*/
ctlr = nil;
for(i = 0; i < Nhcis && ctlrs[i] != nil; i++){
ctlr = ctlrs[i];
if(ctlr->active == 0)
if(hp->port == 0 || hp->port == (uintptr)ctlr->capio){
ctlr->active = 1;
break;
}
}
iunlock(&resetlck);
if(ctlrs[i] == nil || i == Nhcis)
return -1;
hp->aux = ctlr;
hp->port = (uintptr)ctlr->capio;
hp->irq = IRQ0usb0;
hp->tbdf = 0;
capio = ctlr->capio;
hp->nports = capio->parms & Cnports;
ddprint("echi: %s, ncc %lud npcc %lud\n",
capio->parms & 0x10000 ? "leds" : "no leds",
(capio->parms >> 12) & 0xf, (capio->parms >> 8) & 0xf);
ddprint("ehci: routing %s, %sport power ctl, %d ports\n",
capio->parms & 0x40 ? "explicit" : "automatic",
capio->parms & 0x10 ? "" : "no ", hp->nports);
ctlr->tdalloc = ucallocalign;
ctlr->dmaalloc = ucalloc;
ctlr->dmafree = ucfree;
ehcireset(ctlr);
ehcimeminit(ctlr);
/*
* Linkage to the generic HCI driver.
*/
ehcilinkage(hp);
hp->shutdown = shutdown;
hp->debug = setdebug;
intrenable(Irqlo, hp->irq, hp->interrupt, hp, hp->type);
return 0;
}
void
usbehcilink(void)
{
addhcitype("ehci", reset);
}